Re: Pipe and wire
Cate this may guide you, as he says Tape the joins in the cables before pulling through.Re: Pipe and wire
I'm surprised no one has suggested using armoured cable, it is a tad more expensive than normal but you do not need to protect that with a pipe, terminating is also a bit more involved than normal cable but it's not rocket science, I would never suggest using an electrical contractor for a job like this, they may have qualifications but I've never known one who can do a decent and safe job, if you really don't know what you are doing then yes you have no choice but mostly this kind of thing is well within the scope of anyone who is prepared to read up a few basics.Re: Pipe and wire
Re: Pipe and wire
Re: Pipe and wire
Tell the truth they were done before I had put my specs on. I think they used one of those snake thingies. All changed now anyway decided that it would make this part of the house too warm so we are having polly tunnel instead. However this did not affect us needing power so the job was well done.Re: Pipe and wire
HI Cookiecate,Re: Pipe and wire
Feed a SINGLE wire through first, bend the first inch of the wire back on itself and clamp together with a pair of pliers, this gives a rounded end to the cable so that if there are any snags inside the pipe, the rounded end will overcome them. When you've got the single wire through, tie it around a stick or similar so that it does not get pulled back. Cut the other end of the wire to give you a foot or so to play with, trim the ends of all the wires so that there is about four inches of bare wire showing and make a substantial join in the single wire and the rest, by interlocking them and making a tight twist with pliers. thin enough to easily pass into the end of the conduit. While one person is carefully pulling the single cable in the garage, another person should be CAREFULLY feeding the cables into the other end trying to feed them in as neatly as possible, with each individual wire sliding in side by side and not twisted around each other. If done properly, as long as you have the right size conduit for the cables, they should go through with no problemThread Tools | |
|